Care Instructions for Weather Shield Fabric

It's best to use a mild, pH-neutral cleaner plus a special Weathershield/fabric cover cleaner, followed by a suitable waterproofing spray for outdoor fabrics (tents, awnings, boat covers).

Cleaning the Weathershield cover

  • Regularly sweep off loose dirt (leaves, dust, pollen) with a soft brush or broom.
  • Rinse the cover with a garden hose or a bucket of clean water.
  • Clean with lukewarm water, a mild, pH-neutral cleaner (no washing-up liquid, no alcohol, no bleach) and a soft sponge or brush.
  • Do not use harsh cleaners, scouring pads or pressure washers, as they damage the fibres and coating.
  • Then rinse thoroughly with clean water and let it air-dry completely before covering again.

Example: there are special Weathershield cleaners such as “Spa Weathershield Care” that are diluted with water and applied with a soft brush.

Waterproofing / refreshing water repellency

  • Weathershield and fabric covers are often waterproofed at the factory. This layer wears off over time and should be renewed regularly.
  • Use a waterproofing spray or liquid waterproofer for synthetic outdoor textiles (tent canvas, boat covers, awnings). These are designed for similar fabrics.
  • The cover must be clean and completely dry. Then spray or apply the waterproofer evenly to the outside (and the inside if needed).
  • After applying, let it dry for several hours, ideally 12–24 hours, so the full protective effect develops.
  • Depending on exposure (lots of sun, lots of rain, proximity to trees), refresh the waterproofing every few months.
Cover König: Made-to-measure thermal cover banner

Made-to-measure thermal covers

Shop now
Cover König: Thermal cover in stock banner

Thermal covers
in stock

Shop now