Whirlpool cover care instructions
A hot tub cover is an investment in your hot tub, and like any investment, you want to protect it. In this guide you'll find care tips that save you money and maximise the life of your cover.

Pollen, leaves, dust and other debris don't just make your cover look unsightly – they can also encourage mould, moss and other damage. Extend the life of your cover and keep it looking good with regular preventive care:
- Rinse with a garden hose and cold water
- Use a mild, pH-neutral, non-foaming cleaner as a spray
- Use a non-abrasive sponge to clean gently
- Rinse thoroughly again and leave to dry
- Repeat monthly
Never use detergents, abrasives, bleach, alcohol, washing-up liquid or other harsh cleaners. These products remove part of the protective layer, causing the fabric to lose its water-repellent effect and the vinyl to become dull.
Stubborn dirt or stains
Occasionally a cover needs more than gentle cleaning. Instead of using products that could damage your cover, proceed as follows:
- For stubborn dirt, let a gentle cleaner work for a few minutes before wiping it off.
- Carefully loosen moss or mould on the seams or zip with a scouring sponge.
- Remove sticky tree sap with vegetable oil or margarine.
- Open the zip to remove mould from inside the cover.
Protection
Once the cover is clean, a protectant will extend its life considerably.
We recommend “LIMBIO Cover Shine” as sun and water protection. It protects the cover from strong UV radiation and moisture.
Protecting the fabric:
- Spray “LIMBIO Cover Shine” onto the clean, dry fabric until it is evenly wetted
- Let the protectant work for 12 to 24 hours
- Treat monthly in summer and every two months for the rest of the year
Protecting vinyl:
- Spray a thin layer of “LIMBIO Cover Shine” onto the underside of the clean, dry cover
- Spread the layer evenly with a damp cloth or sponge
- Repeat on the top and edge of the cover
- Treat monthly in summer and every two months for the rest of the year
Our kits for WeatherShield Fabric and Vinyl contain everything you need to clean and protect your cover.
Special instructions for Weathershield material:
It's best to use a mild, pH-neutral cleaner plus a special Weathershield/fabric cover cleaner, followed by a suitable waterproofing spray for outdoor fabrics (tents, awnings, boat covers).
Cleaning the Weathershield cover
- Regularly sweep off loose dirt (leaves, dust, pollen) with a soft brush or broom.
- Rinse the cover with a garden hose or a bucket of clean water.
- Clean with lukewarm water, a mild, pH-neutral cleaner (no washing-up liquid, no alcohol, no bleach) and a soft sponge or brush.
- Do not use harsh cleaners, scouring pads or pressure washers, as they damage the fibres and coating.
- Then rinse thoroughly with clean water and let it air-dry completely before covering again.
Example: there are special Weathershield cleaners such as “Spa Weathershield Care” that are diluted with water and applied with a soft brush.
Waterproofing / refreshing water repellency
- Weathershield and fabric covers are often waterproofed at the factory. This layer wears off over time and should be renewed regularly.
- Use a waterproofing spray or liquid waterproofer for synthetic outdoor textiles (tent canvas, boat covers, awnings). These are designed for similar fabrics.
- The cover must be clean and completely dry. Then spray or apply the waterproofer evenly to the outside (and the inside if needed).
- After applying, let it dry for several hours, ideally 12–24 hours, so the full protective effect develops.
- Depending on exposure (lots of sun, lots of rain, proximity to trees), refresh the waterproofing every few months.
